|
[Sponsors] |
ICEM cfd 2d tetra mesh with Prism layer Problem |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 4, 2018, 14:26 |
ICEM cfd 2d tetra mesh with Prism layer Problem
|
#1 |
New Member
Join Date: Nov 2015
Posts: 10
Rep Power: 10 |
Hi everyone,
I have small but important problem. Everybody knows the fluent 2D tutorial for periodic flow for a heat exchanger. But I would like to do is, I want to obtain same mesh with ICEM cfd to improve my meshing skills. However, I can't managed to get prism layer for the walls. Tetra mesh can be obtained. however, Even blayer option is enabled, I can't get the prism layer. This issue has been reported with others as well but I couldn't find a solution on the net. Kindly share your thoughts |
|
Tags |
2d tetra mesh, icem cfd, prsim layer |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM - problems with prism mesh | João Lourenço | CFX | 2 | September 18, 2019 03:07 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent | sonic109 | ANSYS Meshing & Geometry | 2 | September 3, 2014 00:56 |
ICEM - Prism Tool Problem | carpe85 | CFX | 0 | February 10, 2009 12:25 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |