 |
 |
 |
|
|
|
[Sponsors] | ||||
March 5, 2018, 18:19
|
ANSYS Workbench Batch Running
|
#1 |
|
Senior Member
Join Date: Feb 2010
Posts: 148
Rep Power: 18  |
I am trying to run ANSYS Mechanical in batch mode. Is anyone aware of a step-by-step tutorial on the subject, preferably with screenshots. I am running in parallel with two HPC licenses on a 32-core machine.
I found a couple of sites but they do not provide step-by-step instructions and one involves Rescale although some of the steps are useful. https://www.sharcnet.ca/Software/Ans..._G_OPE3_4.html https://resources.rescale.com/articl...-in-batch-mode It seems that there is not good information available in the Mechanical User's Guide. Thanks so much for any information. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent in Ansys Workbench : Change Working Directory | sral | FLUENT | 4 | March 29, 2019 10:29 |
| Ansys SIG$ILL error | loth | ANSYS | 3 | December 24, 2015 05:31 |
| 2-way FSI in Ansys CFX 15 | LucasGasparino | CFX | 3 | August 6, 2015 03:17 |
| Question on running CFX simulations in workbench parameter set table | Anna Tian | CFX | 0 | September 20, 2014 01:51 |
| [ICEM] ICEM CFD error when running in batch mode | bgp723 | ANSYS Meshing & Geometry | 0 | August 14, 2014 13:45 |
Linear Mode
