Move blocks in ANSYS Workbench

MarcelloAsciolla · May 28, 2018, 22:13

I often use the "copy" of a subsystem (block of geometry, block of mesh, ...) and I edit it. But I do not like the way ANSYS places them. Sometime they are placed on the side, sometime they placed are under, sometime they are shifted in diagonal... and this is very annoying, so my simple question: is there a way to change the position of a block in ANSYS Workbench once it is created?

siw · June 5, 2018, 10:09

I think you are wanting to move Analysis Systems around a Workbench Project. It is possible to grab and drag them to any area indicated in green. You cannot just put them anywhere you want though.

May 28, 2018, 22:13	Move blocks in ANSYS Workbench	#1
MarcelloAsciolla Member Marcello Asciolla Join Date: Apr 2018 Location: Italy Posts: 43 Rep Power: 8	I often use the "copy" of a subsystem (block of geometry, block of mesh, ...) and I edit it. But I do not like the way ANSYS places them. Sometime they are placed on the side, sometime they placed are under, sometime they are shifted in diagonal... and this is very annoying, so my simple question: is there a way to change the position of a block in ANSYS Workbench once it is created?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Workbench 18.2 Installation Error Ubuntu 16.04	turbostudent	ANSYS	1	October 3, 2019 10:13
Ansys Workbench Fracture and Cracking Behavior using Solid65	jackhero	Structural Mechanics	0	December 25, 2017 00:45
[Commercial meshers] COnvert FLuent MEsh to openfoam with interface	manuc	OpenFOAM Meshing & Mesh Conversion	1	July 25, 2017 03:13
FLUENT installation on UBUNTU 12.04 (LTS)	teymourj	FLUENT	2	March 1, 2017 22:24
Export Heat Flux CFX -> ANSYS Workbench	Freeman	CFX	2	April 11, 2010 08:24