Home > Forums > Software User Forums > ANSYS

Problem in Clod Flow Simulation of IC Engine in ANSYS

Updated Threads

Reply

Search this Thread

August 14, 2018, 05:55	Problem in Clod Flow Simulation of IC Engine in ANSYS	#1
Rajat Arya New Member Rajat Arya Join Date: Aug 2018 Posts: 3 Rep Power: 7	Hey, I am doing Cold Flow Simulation of IC Engine in ANSYS 16.2 and facing some problems regarding it. Divergence Detected in AMG Solver. Negative cell volume detected. I am doing full cycle simulation 0-720 Crank angle but after some crank angles these errors appears and solution stops. Pressure Based solver is used and K-E RNG model is used for turbulence modeling....Please give me some suggestions and Solutions so that I can analyze it properly.

Reply

Tags

cold flow simulation, ic engine

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem - simulation crashes by changing flow velocity	Harak	OpenFOAM Running, Solving & CFD	19	February 12, 2015 23:26
Propeller flow simulation in Ansys Fluent	a1ananth	FLUENT	2	December 4, 2014 15:30
ANSYS 15 CFD or Solidworks flow simulation	William_T	Main CFD Forum	1	October 30, 2014 03:41
problem in slug flow simulation	abdoganawa	Main CFD Forum	0	March 17, 2013 10:35
problem of river flow simulation	Liu	Main CFD Forum	0	May 27, 2004 22:01

All times are GMT -4. The time now is 06:31.