Die design for coextrusion -- CFD Online Discussion Forums

September 20, 2018, 09:22	Die design for coextrusion	#1
Anna2018 New Member Join Date: Sep 2018 Location: Brindisi Posts: 1 Rep Power: 0	Hello every one, it is possible to perform a simulation of the inverse prediction for a coextrusion case, to design the die? I'm getting the following error while trying to simulate the inverse coextrsuion process: Dimension fault : no place anymore in the modification list. Value of parameter MAXMOD must be increased (modiftbl.com). We must leave Polydata now. We apologize for the inconvenience. (error code #25 detected) Any idea? Thanks and Regards

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sensitivity information for custom design variables	dghate	SU2	0	March 20, 2017 06:39
Component update can be performed only in base design point	Domenico83	CFX	0	March 10, 2017 05:48
JOB: Sr. Thermal/Mechanical Design Engineer	Dee Dee Dial	Main CFD Forum	0	April 1, 2003 18:49
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 10:18
CFD - Trends and Perspectives	Jonas Larsson	Main CFD Forum	16	August 7, 1998 16:27

All times are GMT -4. The time now is 08:17.