|
[Sponsors] |
Is it possible somehow to import a 19.1 file into 19.0 version? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 24, 2018, 16:30 |
Is it possible somehow to import a 19.1 file into 19.0 version?
|
#1 |
New Member
Join Date: Sep 2018
Posts: 16
Rep Power: 8 |
Is there a valid path, like converting the 19.1 ANSYS file into a Solidworks document and then importing this Solidworks document into the 19.0 ANSYS?
|
|
October 31, 2018, 15:34 |
|
#2 |
Senior Member
Erik
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 1,185
Rep Power: 23 |
No, Ansys is not forward compatible.
|
|
Tags |
conversion, conversion error |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 07:47 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 11:59 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 12:44 |