 |
 |
 |
|
|
|
[Sponsors] | ||||
April 3, 2019, 20:05
|
moving objects in workbench
|
#1 |
|
Senior Member
Svetlana Tkachenko
Join Date: Oct 2013
Location: Australia, Sydney
Posts: 415
Rep Power: 14  |
The objects 'A' 'B' 'C' etc in workbench are located inconveniently. When I click 'duplicate' there is nowhere to choose where to put it. Now the whole set does not fit my screen anymore. I already see that it is possible to zoom in and out, and scroll the page, and to rename each of these objects. However is it possible to move them around?
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Workbench 18.2 Installation Error Ubuntu 16.04 | turbostudent | ANSYS | 1 | October 3, 2019 10:13 |
| General moving objects, flow 3d | Alqadami Ebra | FLOW-3D | 1 | February 19, 2019 12:12 |
| FLUENT installation on UBUNTU 12.04 (LTS) | teymourj | FLUENT | 2 | March 1, 2017 22:24 |
| Ansys Workbench moving heat source and laser cladding? | eap88 | ANSYS | 1 | April 27, 2016 01:30 |
| moving objects | fan jinglng | Phoenics | 0 | August 26, 2002 03:58 |
Linear Mode
