 |
 |
 |
|
|
|
[Sponsors] | ||||
July 7, 2019, 12:22
|
Udf fluent: automating air flow in air duct
|
#1 |
|
Senior Member
AH
Join Date: Apr 2014
Posts: 282
Rep Power: 12  |
Need some help please, anyone.
Attached file shows a flow chart for a c++, with initial c++ code shown. Writing c++ UDF independent, since I will be compiling outside fluent first. Will adapt to udf fluent format later. A flow sensor measures air speed in duct. Based on preset airflow speed, pressure is adjusted by 10% (increase or decrease) depending on airflow speed. Increments/decrements of 10% per a loop is done per a conditional airflow check, till required airflow is achieved. The attached flowchart should clarify this. Thanks in advance. If you can't see attachment, will upload again. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Modeling Furnace Air Flow | elisioo | FLUENT | 0 | April 4, 2019 09:16 |
| Ansys fluent: Turbulent air through duct | GreenJayPackers | CFD Freelancers | 6 | May 11, 2016 03:14 |
| Evaporation Modelling of a single droplet resting on a heated duct with air flow | shashankmechguy | Fluent Multiphase | 0 | June 11, 2015 10:46 |
| Different flow patterns in CFX and Fluent | avi@lpsc | CFX | 6 | April 17, 2012 01:22 |
| UDF, air flow through a cell----get velocity in | lig | FLUENT | 0 | September 6, 2010 13:02 |
Linear Mode
