Unable to start geometry editor - Centos7
Hi Everybody,
I researched a lot of forums to solve this problem. But they don't help me. Ansys licences are works very well. Workbench is opened normally. But when i create the fluent environment and i try to open the Geometry editor the following error pop-up: Unable to start the geometry editor. Please help System: centos7 Ansys version: 19.0 |
I know it passed some time since the post showed up, but I found the same problem just now. I have exactly the same setup as you specified (OS and ANSYS WB version). I use a workflow made of 3 blocks, i.e. geometry, mesh and Fluent... What I found is that only geometry and mesh don't run while Fluent starts and proceed smoothly. Another interesting fact is that all these worked well till the Febrary/March this year. Since I haven't use it (geometry or mesh) for some time so I haven't realized the problem exists. If someone knows some solution or find similar problem would be nice to know.
Regards, Piotr |
All times are GMT -4. The time now is 05:38. |