[IMPORTANT] Propeller Meshing and Boundary Layer

propellermesher · January 3, 2020, 08:36

Hello fellow CFD-ers.

I have been trying to achieve to Mesh as attached but I change the mesh of the boundary layer also everytime I change the mesh size. Is there anyone who can advise me on this?

mesh.JPG

Thank you very much.

Gert-Jan · January 6, 2020, 09:10

What are you trying to accomplish?

propellermesher · January 6, 2020, 23:44

Hello! Thank you very much for the reply.

I am trying to find the torque, thrust and power produced by the propeller.

Thus, I am trying to obtain a mesh that helps me to accurately mesh the blades only and not the boundary layer.

Gert-Jan · January 7, 2020, 03:19

Why do you think you should not mesh the boundary layer accuratel?

metaliat93 · January 28, 2020, 02:41

Quote:

Originally Posted by propellermesher

Hello! Thank you very much for the reply.

I am trying to find the torque, thrust and power produced by the propeller.

Thus, I am trying to obtain a mesh that helps me to accurately mesh the blades only and not the boundary layer.

can you show waht are you doing with mesh settings?

January 3, 2020, 08:36	[IMPORTANT] Propeller Meshing and Boundary Layer	#1
propellermesher New Member Propeller Join Date: Jan 2020 Posts: 2 Rep Power: 0	Hello fellow CFD-ers. I have been trying to achieve to Mesh as attached but I change the mesh of the boundary layer also everytime I change the mesh size. Is there anyone who can advise me on this? mesh.JPG Thank you very much.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] layer not added	Rasmusiwersen	OpenFOAM Meshing & Mesh Conversion	1	January 2, 2020 09:43
Question about adaptive timestepping	Guille1811	CFX	25	November 12, 2017 17:38
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6	prashanthreddyh	ANSYS Meshing & Geometry	1	December 20, 2011 00:35
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 13:47

January 6, 2020, 09:10		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,827 Rep Power: 27	What are you trying to accomplish?

January 6, 2020, 23:44		#3
propellermesher New Member Propeller Join Date: Jan 2020 Posts: 2 Rep Power: 0	Hello! Thank you very much for the reply. I am trying to find the torque, thrust and power produced by the propeller. Thus, I am trying to obtain a mesh that helps me to accurately mesh the blades only and not the boundary layer.

January 7, 2020, 03:19		#4
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,827 Rep Power: 27	Why do you think you should not mesh the boundary layer accuratel?