3D wing meshing issues on inlet (ICEM)
4 Attachment(s)
Dear All,
I am currently trying to mesh a 3D S809 profile blade. It is 0.1 m spanwise only as I am limited to 512,000 cells. However I can't seem to get a mesh in the spanwise direction on my inlet, there are 30 nodes along the spanwise direction (the semi-circular and upper/lower wall area). I can however, get spanwise nodes along my outlet and blade. I know this is probably an association issue but I can't seem to figure it out. Photos are attached for reference. I appreciate any help. Sincerely, Sakib. |
All times are GMT -4. The time now is 06:46. |