Home > Forums > Software User Forums > ANSYS

meshing

Mark Forums Read

Reply

Search this Thread

May 17, 2020, 22:01	meshing	#1
shohag New Member shohag Join Date: Oct 2019 Location: australia Posts: 29 Rep Power: 7	i am meshing hydrocyclone. due to ogrid block,at the center all the edges take nodes of parallel edges which are at the wall of the body. so at the center, mesh is very fine. but i need coarse mesh at the center. how can i do this? can anyone help?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] only automatic meshing works,	kazra	ANSYS Meshing & Geometry	2	February 23, 2017 11:38
[ICEM] Flow channel meshing problems	StefanG	ANSYS Meshing & Geometry	19	May 15, 2012 06:44
[ANSYS Meshing] Meshing strategy for External Flows	Hybrid	ANSYS Meshing & Geometry	0	January 24, 2012 14:27
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 11:03
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08

All times are GMT -4. The time now is 06:26.