 |
 |
 |
|
|
|
[Sponsors] | ||||
ANSYS CFD: Cannot achieve independent face meshing |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 27, 2020, 16:08
|
ANSYS CFD: Cannot achieve independent face meshing
|
#1 |
|
New Member
Jagrut Brahmbhatt
Join Date: May 2020
Posts: 2
Rep Power: 0  |
Please go through the attachment. On the left is the desired meshing and on the right is the mesh created by me.
In the right one, I have applied "no of divisions_sizing" method at the boundary. But when I mesh the adjacent surface mesh through mapped face meshing, the generated mesh is very skewed. Can someone help me make a mesh like that of the left image? I feel that the boundary condition doesnt apply to the adjacent Trianglular mesh, but how is this possible? Or is there any other method to achieve the desired mesh? Last edited by Jagrut Brahmbhatt; May 27, 2020 at 16:09. Reason: want to add an email notification |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
| [snappyHexMesh] Invalid Normals for source face to target face while making AMI? | Sorabh | OpenFOAM Meshing & Mesh Conversion | 1 | August 3, 2021 06:35 |
| [ANSYS Meshing] Ansys meshing does not respond when it is opened after the first time | MikhO | ANSYS Meshing & Geometry | 0 | February 16, 2018 08:08 |
| [Other] ANSYS Meshing vs ICEM CFD | jayyeahhkay | ANSYS Meshing & Geometry | 6 | December 14, 2014 00:43 |
| [ANSYS Meshing] Ansys meshing with extended meshing | jsm | ANSYS Meshing & Geometry | 6 | January 10, 2011 12:09 |
Linear Mode
