 |
 |
 |
|
|
|
[Sponsors] | ||||
September 3, 2020, 10:06
|
Add a mass on a node
|
#1 |
|
New Member
David
Join Date: Sep 2020
Posts: 1
Rep Power: 0  |
Hello everyone,
I'm very new to Ansys Workbench. I've meshed a simple beam and I would like to add a mass at the end of it to perform a modal analysis followed by a spectral analysis. I would like the mass to be considered for both analysis but i just can't find how to add this mass on the meshed beam. Can someone help me to do that ? Thanks a lot 
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 15:18 |
| Phi error in implimenting Kepsilon in DPMFoam | kinbean | OpenFOAM | 3 | December 19, 2017 18:11 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| HELP PLS: Simplefoam manipulated to add diffusive mass transport...but solver stops!! | 1gn0rant | OpenFOAM Running, Solving & CFD | 1 | August 13, 2010 12:02 |
Linear Mode
