Home > Forums > Software User Forums > ANSYS

polyurethane fire

Mark Forums Read

Reply

Search this Thread

September 6, 2020, 17:35	polyurethane fire	#1
yosefBO New Member yousef Join Date: Jan 2020 Posts: 10 Rep Power: 7	Hi everyone I hope you are in good health I am going to simulate fire in metro and the Heat relase rate will be consdired as 20 mw by ANSYS FLUENT I am looking to use fuel of polyurethane materials as representive of train content. My question : what should i recognise about the feul in order to be put in ANSYS FLUENT Joseph

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
polyurethane fire	yosefBO	Main CFD Forum	0	September 6, 2020 17:22
PhD thesis with funding - Modelling of Fire Suppression in Heritage Buildings	AxelCable	CFD Freelancers	1	June 30, 2020 15:05
Boundary conditions in fireFoam - tunnel fire	ingraban	OpenFOAM Running, Solving & CFD	9	July 8, 2019 09:57
Car park ventilation and impulse fans	guillaume	Phoenics	9	October 27, 2015 06:57
Wildland surface fire representation in OpenFOAM	Bufacchi	OpenFOAM	0	June 4, 2010 13:07

All times are GMT -4. The time now is 14:03.