[davidash23]

Hi,

When I try to run my mechanical model I quickly get an error saying "An error occurred while starting the solver module."

I know the Ansys guide suggests a few possible reasons for this error relating to insufficient memory or disk space.

However this model is running on a remote access HPC with which I know I'm not running out of either. I also know that the installation is not corrupt or that the license is not giving me a twc email problem since I first ran a model through Fluent just fine, and imported the results to mechanical, and never had an issue with the license.

The Solution Information folder in the tree is giving me nothing but a blank page so no info from there.

What could be causing this problem? Any help would be greatly appreciated

Thanks!