 |
 |
 |
|
|
|
[Sponsors] | ||||
November 27, 2020, 10:49
|
Ansys
|
#1 |
|
New Member
karan
Join Date: Aug 2020
Posts: 2
Rep Power: 0  |
The issue occurred in the cross-section process. Since you don't pick the correct face as a limit. On the off chance that your model contains 3 bodies, and you need to pick and name a face in one of the bodies, you would be wise to conceal the other two bodies so you don't pick an inappropriate face. The stream limit id is an inappropriate face you picked. Return to your cross-section programming and rechoose the face, at that point there would be no issue.
geforce pour pc |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
| [ANSYS Meshing] ANSYS mesh - I was surprised... | assafwei | ANSYS Meshing & Geometry | 0 | September 4, 2014 12:17 |
| Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 16:00 |
| Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 10:28 |
| Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |
Linear Mode
