Boolean function

tjwldhks79 · February 6, 2024, 03:47

Hello, everyone.

I'm working on simulating the drag coefficient of a sphere.

In DesignModeler, I can create a sphere and use the 'Enclosure' function. By employing the 'Boolean' function, I can generate the geometry for my simulation.

However, in SpaceClaim, even after creating a sphere and using the 'Enclosure' function, I couldn't find the 'Boolean' option button...

Can someone help me?

I apologize for my limited English proficiency.

Thank you for reading my question.

Gert-Jan · February 6, 2024, 05:10

Why not create a sphere and a box and then combine them using:

Design > Combine

In this menu, you can join or subrtract objects. Whatever you like.

tjwldhks79 · February 7, 2024, 21:04

Thanks, I will try it

February 6, 2024, 03:47	Boolean function	#1
tjwldhks79 New Member eddy Join Date: Jan 2024 Posts: 19 Rep Power: 2	Hello, everyone. I'm working on simulating the drag coefficient of a sphere. In DesignModeler, I can create a sphere and use the 'Enclosure' function. By employing the 'Boolean' function, I can generate the geometry for my simulation. However, in SpaceClaim, even after creating a sphere and using the 'Enclosure' function, I couldn't find the 'Boolean' option button... Can someone help me? I apologize for my limited English proficiency. Thank you for reading my question.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculating source term total cell-zone volume parallel computation	RobV	Fluent UDF and Scheme Programming	2	May 30, 2022 03:46
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
ParaView for OF-1.6-ext	Chrisi1984	OpenFOAM Installation	0	December 31, 2010 06:42
Compilation errors in ThirdPartymallochoard	feng_w	OpenFOAM Installation	1	January 25, 2009 06:59
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50

February 6, 2024, 05:10		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,827 Rep Power: 27	Why not create a sphere and a box and then combine them using: Design > Combine In this menu, you can join or subrtract objects. Whatever you like.

February 7, 2024, 21:04		#3
tjwldhks79 New Member eddy Join Date: Jan 2024 Posts: 19 Rep Power: 2	Thanks, I will try it