Tangential Velocity in Cyclone Separator
4 Attachment(s)
Hello everyone, I have tried to simulate a cyclone separator with ANSYS Fluent. In setting solution in Workbench I have followed the steps and instructions according to the validation journal. However, my simulation tangential velocity contour results are different from the validation journal. In the validation journal the tangential velocity contour on the center of cyclone should be low but in my simulation contour it is high. However, the contours of the pressure drop and the axial velocity are appropriate.
Note : I used reynold stress turbulence model (RSTM) and Discrete Phase Model (DPM) to injection modeling Can you help me solve this problem?:) Attachment 85087 Attachment 85088 Attachment 85089 Attachment 85090 |
All times are GMT -4. The time now is 21:27. |