 |
 |
 |
|
|
|
[Sponsors] | ||||
September 14, 2021, 11:21
|
parachute dynamics simulation
|
#1 |
|
New Member
Join Date: Mar 2021
Posts: 14
Rep Power: 5  |
Mesh Quality:
Minimum Orthogonal Quality = 9.05742e-04 cell 12017 on zone 6 (ID: 12018 on partition: 0) at location (-1.12565e-01 1.24336e+01 2.98048e+00) (To improve Orthogonal quality , use "Inverse Orthogonal Quality" in Fluent Meshing, where Inverse Orthogonal Quality = 1 - Orthogonal Quality) Warning: minimum Orthogonal Quality below 0.01. Maximum Aspect Ratio = 1.75935e+02 cell 720718 on zone 3 (ID: 733370 on partition: 0) at location (-6.39347e-02 1.24552e+01 2.99726e+00) Fluent can try to improve the mesh quality via the TUI command /mesh/repair-improve/improve-quality how to improve the mesh quality? How to make this error solved |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to set the correct material datas for composite simulation in Explicit Dynamics i | asuasura | ANSYS | 1 | June 12, 2018 23:20 |
| Surface Source - Fixed Temperature? | robtheslob | FloEFD, FloWorks & FloTHERM | 18 | May 12, 2017 02:28 |
| Simulation FPEs - turbulence for transient and steady-state? | DaveR | OpenFOAM Running, Solving & CFD | 5 | March 5, 2017 15:06 |
| Huge file sizes when Running VOF simulation | aarratia | FLUENT | 0 | May 8, 2014 12:27 |
| Resume Transient simulation | HMR | CFX | 1 | June 28, 2011 21:13 |
Linear Mode
