Importing a Slotted Airfoil into Ansys, however error appears when creating 3D curve
 

Hello,

I am trying to run some tests on a S103, a slotted airfoil. This airfoil essentially has two elements, and I was thinking I should import each one individually and figure out the rest in Ansys. However, When I go to import the first part of the airfoil into ANSYS through a 3D curve, it gives me "Error reading Coordinates File". I have looked in the forum and tried the existing solutions but have failed in solving this issue. The file is attached.

If you have any questions please let me know. Any help would be appreciated.

Solution
 

Ignore this, I for some reason forgot Fusion 360 existed so I just modeled the airfoil in there and imported into Ansys.