 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2024, 03:18
|
3D Airfoil Analysis with Vortex Generator
|
#1 |
|
New Member
Leto
Join Date: Apr 2024
Posts: 1
Rep Power: 0  |
Hello,
This is my first post on this forum, thank you in advance for your help. I want to create an analysis to investigate the effect of vortex generators on a 3D NACA 0012 airfoil profile. However, when creating the flow domain, the vortex generators end up inside the domain. I cannot select the parts that are inside, which results in a poor mesh for those parts. How can I properly create the flow domain, or is there a command in Ansys Meshing that allows me to select these parts? |
|
|
|
|
 |
| Tags |
| airfoil 3d, vortex generator |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| laminar or turbulent flow for vortex generator | un-cfd | Main CFD Forum | 1 | April 22, 2024 19:33 |
| 3D airfoil analysis using LES turbulence model | mdsa3d | FLUENT | 0 | December 27, 2020 06:07 |
| Vortex generator | Omar_BEN | FLUENT | 0 | December 3, 2020 09:32 |
| [ICEM] Vortex generator design vİth multi angle of attack | muhammd | ANSYS Meshing & Geometry | 0 | June 13, 2019 05:09 |
| Structured Airfoil Grid Generator | A.S. | Main CFD Forum | 1 | September 30, 2008 18:29 |
Linear Mode
