Full Wing CFX Mesh Help
 

Hello,

I am relatively new to using CFX, and cannot seem to figure out how to get my wing model meshed. I modeled the wing in Inventor and cut it out of a box in Design Modeler for the boundary.

When trying to mesh the wing, I get a few errors: faces with small angles, small internal angles, boundary edge does not exit face, and no exit from face found.
For the first two, I usually can just create some virtual faces to fix the problems, but when I try to create a virtual face, it says the model contains calues that are invalid.
For the last two errors, I am not sure what the problem is or how to fix it.

http://smg.photobucket.com/albums/v2...=winginbox.jpg
http://smg.photobucket.com/albums/v2...winginbox2.jpg

I've been mostly referenceing the blunt body tutorial for setting this up, if that provides any more information.


I would greatly appreciate any help or advice.

Hey did u manage to figure out a solution...if so do u mind sharing the same with me!..Please email me at amoolraina@hotmail.com ...Thanks