 |
 |
 |
|
|
|
[Sponsors] | ||||
June 11, 2009, 11:44
|
Heat transfer
|
#1 |
|
New Member
rishabh chandra
Join Date: Jun 2009
Posts: 3
Rep Power: 16  |
hi guys..
The problem is air is flowing in a tank, and the tank is heated externally with heaters. I have to model the temperature change of air..my geometry is basically just a tank with an inlet and an outlet first i tried to run the problem with a constant heat flux into the wall, and i got a huge temperature rise, which is wrong. then i added convection coefficient, which gave me almost no rise in air temperature..which again is wrong.. any suggestions on how i should proceed? thanks! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat transfer coefficient - what is waht | Stan | FLUENT | 28 | December 29, 2021 16:29 |
| How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
| CFX Heat Transfer | RJamison | CFX | 0 | July 24, 2008 12:11 |
| Question on heat transfer coefficient!!! | Benny | FLUENT | 7 | June 7, 2005 09:25 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
