CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS (https://www.cfd-online.com/Forums/ansys/)
-   -   Dynamic Mesh Can not Be Used in FLUENT 12.0 (https://www.cfd-online.com/Forums/ansys/66837-dynamic-mesh-can-not-used-fluent-12-0-a.html)

lzgwhy July 26, 2009 00:01

Dynamic Mesh Can not Be Used in FLUENT 12.0
 
When I used the dynamic macro provided by FLUENT 12.0 to control the mesh motion on the Windows XP 64-bit platform, I found that the mesh motion can not be previewed. The following is details. The C codes including dynamic macros and some other macros were compiled successfully by Visual C++ 2008 without any errors in FLUENT, and the compiled codes were loaded successfully, however, when I previewed the mesh motion, FLUENT was turned off by itself after a few minutes. I wonder what is wrong in this process? Thanks.

galina April 18, 2010 19:19

Dyamic Mesh
 
Quote:

Originally Posted by lzgwhy (Post 224136)
When I used the dynamic macro provided by FLUENT 12.0 to control the mesh motion on the Windows XP 64-bit platform, I found that the mesh motion can not be previewed. The following is details. The C codes including dynamic macros and some other macros were compiled successfully by Visual C++ 2008 without any errors in FLUENT, and the compiled codes were loaded successfully, however, when I previewed the mesh motion, FLUENT was turned off by itself after a few minutes. I wonder what is wrong in this process? Thanks.

I wonder if you can help me to setup Visual C++ 2008 correctly. I cannot compile my C code. Thanks for your help


All times are GMT -4. The time now is 07:35.