unable to start the meshing editor
I am using ANSYS Workbench 12.1. After the geometry was imported, and then each time when I start the mesher to mesh geometry, it took a very long time to respond and finally it is not responding. Error message says "unable to start the meshing editor". What is wrong?Thanks guys.
|
Quote:
Following worked for me. //Run the following command in the terminal prior to starting the workbench unset SLURM_GTIDS //Run ANSYS Workbench module load workbench/19.2 runwb2 -oglmesa |
Quote:
|
All times are GMT -4. The time now is 05:03. |