|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Dongzi Wei
Join Date: Mar 2009
Posts: 33
Rep Power: 18 ![]() |
I am using ANSYS Workbench 12.1. After the geometry was imported, and then each time when I start the mesher to mesh geometry, it took a very long time to respond and finally it is not responding. Error message says "unable to start the meshing editor". What is wrong?Thanks guys.
|
|
![]() |
![]() |
![]() |
![]() |
#2 | |
New Member
Pradeep
Join Date: May 2022
Posts: 1
Rep Power: 0 ![]() |
Quote:
Following worked for me. //Run the following command in the terminal prior to starting the workbench unset SLURM_GTIDS //Run ANSYS Workbench module load workbench/19.2 runwb2 -oglmesa |
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Renhua Peng
Join Date: Jun 2023
Posts: 1
Rep Power: 0 ![]() |
Hi, I Just run into the same problem, and tried your method. But I can find the unset command in the terminal(Windows 10, Anasys Workbench 2022R2), Any other suggestion?
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unable to start calculations | vidya | FLUENT | 0 | August 5, 2009 08:59 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Unable to start fluent in parallel mode | Anand | FLUENT | 1 | January 11, 2009 16:48 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |