CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS

unable to start the meshing editor

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   March 30, 2010, 12:21
Default unable to start the meshing editor
  #1
Member
 
Dongzi Wei
Join Date: Mar 2009
Posts: 33
Rep Power: 17
Jiuan is on a distinguished road
I am using ANSYS Workbench 12.1. After the geometry was imported, and then each time when I start the mesher to mesh geometry, it took a very long time to respond and finally it is not responding. Error message says "unable to start the meshing editor". What is wrong?Thanks guys.
Jiuan is offline   Reply With Quote

Old   April 10, 2023, 17:16
Default
  #2
New Member
 
Pradeep
Join Date: May 2022
Posts: 1
Rep Power: 0
pparajuli308 is on a distinguished road
Quote:
Originally Posted by Jiuan View Post
I am using ANSYS Workbench 12.1. After the geometry was imported, and then each time when I start the mesher to mesh geometry, it took a very long time to respond and finally it is not responding. Error message says "unable to start the meshing editor". What is wrong?Thanks guys.
You might have already figured out the issue.
Following worked for me.

//Run the following command in the terminal prior to starting the workbench

unset SLURM_GTIDS

//Run ANSYS Workbench

module load workbench/19.2
runwb2 -oglmesa
pparajuli308 is offline   Reply With Quote

Old   June 8, 2023, 05:25
Default
  #3
New Member
 
Renhua Peng
Join Date: Jun 2023
Posts: 1
Rep Power: 0
razorenhua is on a distinguished road
Quote:
Originally Posted by pparajuli308 View Post
You might have already figured out the issue.
Following worked for me.

//Run the following command in the terminal prior to starting the workbench

unset SLURM_GTIDS

//Run ANSYS Workbench

module load workbench/19.2
runwb2 -oglmesa
Hi, I Just run into the same problem, and tried your method. But I can find the unset command in the terminal(Windows 10, Anasys Workbench 2022R2), Any other suggestion?
razorenhua is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Unable to start calculations vidya FLUENT 0 August 5, 2009 09:59
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, cfdproject OpenFOAM Meshing & Mesh Conversion 0 April 14, 2009 16:45
Unable to start fluent in parallel mode Anand FLUENT 1 January 11, 2009 17:48
Singularity of grid?Volume meshing vs face meshing Ken Main CFD Forum 0 September 4, 2003 12:09
Volume Meshing & Face Meshing? singularity of grid ken FLUENT 0 September 4, 2003 12:08


All times are GMT -4. The time now is 10:32.