|
[Sponsors] |
April 6, 2016, 14:52 |
Create internal fluid volume
|
#1 |
New Member
Muh
Join Date: Apr 2016
Posts: 14
Rep Power: 10 |
Dear friends,
I have a geometry with two bodies on top of each other with some distance, and its closed with surface bodies and surface patch on the sides. I tried the fill by caps operational but it did not work. Creating frozen bodies with extrude may be possible but very difficult for this geometry. How do I create internal fluid volume? Yours sincerely, Last edited by Muh; April 6, 2016 at 15:59. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |