CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS

Mesh Check Failed, Please Help!

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   August 21, 2010, 00:07
Default Mesh Check Failed, Please Help!
  #1
fyp
New Member
 
FYP
Join Date: Aug 2010
Posts: 3
Rep Power: 15
fyp is on a distinguished road
When using FLUENT to check mech, there is an error message saying that "Warning: mech check failed". But it had passed the mesh check by using ICEM. Please advice. Thanks.
fyp is offline   Reply With Quote

Old   August 26, 2010, 01:05
Default
  #2
Member
 
Arash
Join Date: Dec 2009
Location: Denmark
Posts: 37
Rep Power: 16
arash_7444 is on a distinguished road
probably, skewness of your mesh is high

is that right?
arash_7444 is offline   Reply With Quote

Old   August 27, 2010, 07:41
Default
  #3
fyp
New Member
 
FYP
Join Date: Aug 2010
Posts: 3
Rep Power: 15
fyp is on a distinguished road
yes, you are right.
thanks
fyp is offline   Reply With Quote

Old   August 28, 2010, 19:09
Default
  #4
New Member
 
Rupak
Join Date: Aug 2010
Location: Rochester, NY
Posts: 6
Rep Power: 15
rupakbanerjee is on a distinguished road
same problem.

do i use a smaller mesh spacing?
rupakbanerjee is offline   Reply With Quote

Old   August 29, 2010, 06:41
Default
  #5
New Member
 
Ben Jimenez
Join Date: Aug 2010
Posts: 5
Rep Power: 15
descendents1 is on a distinguished road
If you are certain skewness is your problem, locate where your problem cells are located. Then you'll want to refine your mesh in those regions (as it is likely there is a cluster of highly skewed cells). Don't refine your entire mesh only to fix one small problem area as it will cut into computation time.
descendents1 is offline   Reply With Quote

Reply

Tags
mesh check failed

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ICEM] surface mesh merging problem everest ANSYS Meshing & Geometry 44 April 14, 2016 07:41
Transient boundary conditions Jarrod Sinclair (Sinclair) OpenFOAM Running, Solving & CFD 133 May 6, 2015 07:21
mesh check failed / degenerated contact points shohin FLUENT 16 April 11, 2014 23:32
Check the skewnesses of your face meshes and make sure the face mesh sizes are not to sophie-l ANSYS Meshing & Geometry 0 April 13, 2009 18:27
user defined function cfduser CFX 0 April 29, 2006 11:58


All times are GMT -4. The time now is 02:03.