 |
 |
 |
|
|
|
[Sponsors] | ||||
September 13, 2010, 07:30
|
How to find HTC in Flotran
|
#1 |
|
New Member
P. Chaudhuri
Join Date: Mar 2010
Posts: 2
Rep Power: 0  |
I have two queries:
1.) Is it possible in Flotran to find the Heat transfer coefficient (HTC), if so, then how? 2.) In Flotarn one can give the wall roughness. But if I hve a square channel, is it possible to give wall roughness (say 0.25 mm) on only one side surface and remaining three side/surfaces are smooth. Any help would be highly appreciated! Regards. P. Chaudhuri paritc@gmail.com |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for SUBOFF model but i can't find it. | Heewon Lee | Main CFD Forum | 7 | March 5, 2017 13:36 |
| Ways to find Mass transfer coefficient using CFD? | tuks_123 | CFX | 10 | April 15, 2011 11:20 |
| HTC problem with multiphase | shogologo | CFX | 0 | April 21, 2010 09:26 |
| Flotran -distributed resitance | Zoltan Lakatos | CFX | 1 | April 14, 2004 08:57 |
| Flotran | Arvind | Main CFD Forum | 0 | May 15, 2002 18:10 |
Linear Mode
