icem and thin parts??

sven82 · September 21, 2010, 07:16

Hello everyone,

for a conjugate heat transfer simulation with thin parts
I need a mesh with more than one cells in each direction.
For the last hours I try to mesh a thin (z) long (xy) part with tets,
the results are not very got, with in all cases only on cell in
the middle of the part, the edges look good. The problem
is the grow factor of the cells. How can I control this for a constant
cellnumber(z) across the part?

Thanks for all answers,

best regards
Sven

rikio · September 26, 2010, 04:09

If it is a regular domain, why not hex?
On the other hand, you can set the max. size of mesh in this special area.

September 21, 2010, 07:16	icem and thin parts??	#1
sven82 Member Sven Degner Join Date: Mar 2009 Location: Zürich Posts: 55 Rep Power: 17	Hello everyone, for a conjugate heat transfer simulation with thin parts I need a mesh with more than one cells in each direction. For the last hours I try to mesh a thin (z) long (xy) part with tets, the results are not very got, with in all cases only on cell in the middle of the part, the edges look good. The problem is the grow factor of the cells. How can I control this for a constant cellnumber(z) across the part? Thanks for all answers, best regards Sven

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface	James Date	CFX	3	August 10, 2012 04:47
Thin Surface	Manu	CFX	0	November 29, 2006 16:13
ICEM, holes in swept surface mesh	Roland	CFX	3	September 13, 2006 08:33
Thin surfaces within a body using DesignModeler?	Forrest	CFX	7	April 5, 2005 08:21
ICEM CFD 5.0 (Tetra) - Internal Wall/Thin Surface	James Date	CFX	3	December 24, 2004 07:41

September 26, 2010, 04:09		#2
rikio Senior Member Rikio Join Date: Mar 2009 Location: SH, China Posts: 182 Blog Entries: 1 Rep Power: 17	If it is a regular domain, why not hex? On the other hand, you can set the max. size of mesh in this special area.