Boundary interaction problem
Hi everyone.
I was just modeling some 2d problems and hit a snag. I have a flow and a block in the flow with a heat flux being supplied from the base of the block however, at the boundary where the block and flow meet there is no interaction. http://i886.photobucket.com/albums/a...on999/flow.jpg http://i886.photobucket.com/albums/a...on999/Temp.jpg The temperature of the flow and block is right and the velocity field shows correctly but the heat isn't being transmitted from the block into the flow. Any ideas? Did I miss a setting somewhere along the line? or the model? |
It's most likely just a scaleing issue. Scope your temperature contour to only the fluid and set the range to Local instead of Global.
|
All times are GMT -4. The time now is 01:44. |