CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   Avoiding triangular blocks (

Lara December 7, 2010 07:24

Avoiding triangular blocks
I am trying to mesh a bluff body with a rear diffuser. The diffuser has an endplate at each end, which is forcing me to create a triangular shaped block on the diffuser ramp. How do I avoid this? Has anyone ever had to block similar geometry?
I've been changing the blocking around for months now but can't seem to find a solution!

ronaldalau December 8, 2010 10:22

Ansys Mesh V13 has hex cut-cell meshing.

Lara December 8, 2010 10:54

I am running v11. is this not available on it? and how does it work?



ronaldalau December 8, 2010 11:30

Its only available on Version 13, which was recently released.

All times are GMT -4. The time now is 01:07.