CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   Deriving Results from Fluent (

coondason May 5, 2011 09:08

Deriving Results from Fluent

I've done everything.
-Created the Geometry.
-Meshed the Geometry.
-Waited a couple of hours for a convergence.

How do i get results??

Now i'll be serious.
I'm examining a 3D flow over a body.
After the calculations i need the following Data:
- Resultant Down-force.
- Resultant Drag.
- Center of Pressure.
- Plots of Pressure/Velocity Distribution along the Upper and Lower curves of the body. (As in airfoil analysis).

How do i do it?
** if needed, i can send a result file.**

I've read a lot of tutorials, and i've been working on this project for a very very long time, I'm desperate for some help.

Thank you very much for your help.

All times are GMT -4. The time now is 02:03.