|
[Sponsors] |
May 5, 2011, 10:08 |
Deriving Results from Fluent
|
#1 |
New Member
Alex
Join Date: Dec 2010
Posts: 9
Rep Power: 16 |
Hello
I've done everything. -Created the Geometry. -Meshed the Geometry. -Waited a couple of hours for a convergence. How do i get results?? Now i'll be serious. I'm examining a 3D flow over a body. After the calculations i need the following Data: - Resultant Down-force. - Resultant Drag. - Center of Pressure. - Plots of Pressure/Velocity Distribution along the Upper and Lower curves of the body. (As in airfoil analysis). How do i do it? ** if needed, i can send a result file.** I've read a lot of tutorials, and i've been working on this project for a very very long time, I'm desperate for some help. Thank you very much for your help. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Feeding Fluent results into another Fluent simulation | fruk | FLUENT | 2 | April 28, 2011 10:05 |
few quesions on ANSYS ICEMCFD and FLUENT | Prakash.Paudel | ANSYS | 0 | August 12, 2010 13:07 |
Exporting temperature results fro fluent to Ansys | vinay kulkarni | FLUENT | 1 | February 21, 2007 04:31 |
Fluent results: stagnation pressure greater .... | Amit Shrestha | FLUENT | 5 | December 8, 2005 09:01 |
Poor Results with RSM in Fluent | boris | FLUENT | 0 | October 31, 2005 19:01 |