|
[Sponsors] |
May 12, 2011, 06:37 |
1D-wall dissapearance anfter convertion
|
#1 |
New Member
Join Date: May 2011
Posts: 7
Rep Power: 15 |
Hello,
i created a 2D duct in ICEM with a half high 1D wall in the middle and used tetra meshing. After conversion to FLUENT the wall in the middle dissapeared. Can anyone help to fix this? Thank you. With hex mesh it workes, when is split the blocking and associate the edge to the curve from the wall in the middle. How can I do that similar with tetra mesh? Last edited by Hgyn; May 12, 2011 at 06:59. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 01:04 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 13:03 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 21:30 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |