Starting an MFX analysis via command line

stone123 · May 13, 2011, 13:58

Hi Everyone,

I have Ansys v13 x64 bit and seems that this version does not have the MFX-Ansys/CFX simulation environment in Ansys Product Luncher.

My problem is that I did not understand how to run an FSI analysis from the command line.

The Ansys guide says that I need to start ANSYS Master typing the command: "ansys130 -p productname -mfm fieldname -ser port...." but I did not really understand where to type this command.

I am wondering if someone with more experience can explain step by step this part that is not clear to me at all.

Many thanks

stone123 · May 19, 2011, 10:29

Hi Everyone,

I hope I was clear with my question. But does anyone had experience with this problem before? or this is so obvious.

Thanks again

stumpy · May 26, 2011, 16:41

In general posting in the CFX forum gets more responses.
Take a look at section 2.6.2.4 in the CFX Solver Manager documentation. MFX runs are launched using cfx5solve.

May 13, 2011, 13:58	Starting an MFX analysis via command line	#1
stone123 New Member salvatore Join Date: Oct 2010 Posts: 7 Rep Power: 17	Hi Everyone, I have Ansys v13 x64 bit and seems that this version does not have the MFX-Ansys/CFX simulation environment in Ansys Product Luncher. My problem is that I did not understand how to run an FSI analysis from the command line. The Ansys guide says that I need to start ANSYS Master typing the command: "ansys130 -p productname -mfm fieldname -ser port...." but I did not really understand where to type this command. I am wondering if someone with more experience can explain step by step this part that is not clear to me at all. Many thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Starting analysis of wing sections.	Jonny6001	FLUENT	0	March 9, 2010 16:52
3D analysis of Ahmed body	Irshad22	FLUENT	0	December 17, 2009 05:33
Problems with analysis starting	superlinzl	STAR-CD	1	July 29, 2009 10:04
MFX analysis	Ema	CFX	5	June 11, 2009 12:04
Is CFD Science or Art ?	John C. Chien	Main CFD Forum	36	October 5, 1999 13:58

May 19, 2011, 10:29		#2
stone123 New Member salvatore Join Date: Oct 2010 Posts: 7 Rep Power: 17	Hi Everyone, I hope I was clear with my question. But does anyone had experience with this problem before? or this is so obvious. Thanks again

May 26, 2011, 16:41		#3
stumpy Senior Member Join Date: Apr 2009 Posts: 531 Rep Power: 22	In general posting in the CFX forum gets more responses. Take a look at section 2.6.2.4 in the CFX Solver Manager documentation. MFX runs are launched using cfx5solve.