 |
 |
 |
|
|
|
[Sponsors] | ||||
January 13, 2011, 11:36
|
Refine mesh in Ansys
|
#1 |
|
New Member
Join Date: Jan 2011
Posts: 3
Rep Power: 15  |
Hello everyone,
I have a problem in Ansys 12. I have a 3D solid model which has a compllicated geometry and I want to refine the mesh of some volumes of it.Does anyone know how I can fix this problem? |
|
|
|
|
|
May 7, 2011, 21:26
|
|
#2 |
|
New Member
Join Date: Jan 2011
Posts: 25
Rep Power: 15 |
are you using Fluent? if yes, then you may use the adapted mesh concept, which you can find it in Fluent manual.
|
|
|
|
|
|
|
May 22, 2011, 13:33
|
|
#3 | |
|
New Member
Join Date: Jan 2011
Posts: 3
Rep Power: 15 |
Quote:
 I am using Ansys 12.0, multiphysics. I think I found the answer, I think that i have to refine the area first and then to give the order to make the required volumes.I tried it and it works. |
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| Ansys 12 Workbench problem when generating volume mesh | Sveink | ANSYS | 5 | January 6, 2010 03:17 |
Linear Mode
