how to mesh this 2D drawing in ansys 13 fluent mesh,thanks!

fossil · August 31, 2011, 12:33

HI ALL
I pretty new in ansys, could you help found out how to mesh this?
how can i make sure do not mesh the cirl inside?
thanks!REC.jpg

Josh · September 5, 2011, 14:05

Hi,

This is very basic. Try some of the tutorials. You could also try an Internet search for "CFD cylinder tutorial CFX" or something similar.

fossil · September 5, 2011, 19:48

Hi Josh ,Thanks very much for your help, i had done that mesh right now. i am pretty new in ansys 13, at the begining ,i learn fluent 6.3 and mesh in gambit, but ansys fluent 13 is diferrent, it should be boolean geometry in DM first

August 31, 2011, 12:33	how to mesh this 2D drawing in ansys 13 fluent mesh,thanks!	#1
fossil New Member hcstudio Join Date: Dec 2009 Posts: 4 Rep Power: 16	HI ALL I pretty new in ansys, could you help found out how to mesh this? how can i make sure do not mesh the cirl inside? thanks!REC.jpg

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
fluent doesnt read 1D coating mesh - advice needed	FuzzyDice	FLUENT	5	September 28, 2011 16:34
Export 2D mesh from ICEM to Fluent	BuilttoSpill	ANSYS Meshing & Geometry	4	August 28, 2010 08:16
Moving mesh in Fluent	fivos	FLUENT	0	April 2, 2010 09:45
Exporting mesh from ANSYS to FLUENT	peksen	FLUENT	0	July 6, 2007 10:32

September 5, 2011, 14:05		#2
Josh Senior Member Joshua Counsil Join Date: Jul 2009 Location: Halifax, Nova Scotia, Canada Posts: 366 Rep Power: 17	Hi, This is very basic. Try some of the tutorials. You could also try an Internet search for "CFD cylinder tutorial CFX" or something similar.

September 5, 2011, 19:48		#3
fossil New Member hcstudio Join Date: Dec 2009 Posts: 4 Rep Power: 16	Hi Josh ,Thanks very much for your help, i had done that mesh right now. i am pretty new in ansys 13, at the begining ,i learn fluent 6.3 and mesh in gambit, but ansys fluent 13 is diferrent, it should be boolean geometry in DM first