 |
 |
 |
|
|
|
[Sponsors] | ||||
October 27, 2011, 13:57
|
Eulerian Granular Model
|
#1 |
|
New Member
Romulo Margotto
Join Date: Oct 2011
Posts: 1
Rep Power: 0  |
Hi,
I'm new to CFD and I'm trying do execute a simple simulation. It's a 2d cutting bed inside a pipe, as shown ins the picture bellow. NEH.JPG Im using the Eulerian granular model, enabling gravity and k-e model.Then addapt>>cells and patch>>volume factor>> phase 2 the marked cells. The mesh is near-wall refined. The behavior of particles is not agreeing with the experiments, any idea? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Erosion model and Eulerian Model | leonozx | FLUENT | 0 | April 7, 2011 05:45 |
| Strain Rate in eulerian model | galeazzo | FLUENT | 0 | January 25, 2005 07:52 |
| RTD determination using eulerian model | ap | FLUENT | 2 | November 29, 2003 10:01 |
| Two phase Eulerian Model Problem | senthil | FLUENT | 5 | May 21, 2003 02:55 |
Linear Mode
