CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   i have a problem?? (

CaNk December 14, 2011 13:40

i have a problem??
hi guys.. i have a problem..
i'm meshing the pipe but end of the mesh ansys say "The default defeaturing was larger than one computed based on size control.The mesher has modified the global defeaturing tolerance accordinqly

what is that? how am i solve this problem...Thank u..

karthickeyan December 15, 2011 05:42

no problem
it is only warning not an error. so don't worry.

All times are GMT -4. The time now is 15:51.