|
[Sponsors] |
January 25, 2012, 11:34 |
Group Injection Flow Rate
|
#1 |
New Member
John
Join Date: Jan 2012
Posts: 3
Rep Power: 14 |
I was wondering, what is the correct way to specify the flow rate in the injections panel of Fluent for a group injection? When it starts iterations, it prints to the screen "Injecting 'x' particles with mass 'm' at t='time' " (where x, m, and time are numbers that depend on your settings, of course). Should the mass 'm' be the total mass of all the particles being injected, or mass of a single particle, or of a single stream? Its a little ambiguous to me, and I want to be sure I'm setting it correctly.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to calculate phase flow rate? | sangramroy | FLUENT | 0 | January 11, 2012 14:02 |
Are my IRIXbs systune parametersb setting correct | lakeat | OpenFOAM Installation | 1 | May 5, 2008 11:48 |
mass flow rate error | Masood | FLUENT | 0 | May 22, 2005 01:32 |
about group injection of DPM model | zwdi | FLUENT | 5 | April 12, 2004 20:31 |
How to use q1 and ground file? | zheh | Phoenics | 5 | September 9, 2001 06:01 |