3d mesh around a wind turbine blade

James Hetfield · March 26, 2012, 17:04

Ive seen many posts here about this issue but nobody has explained step by step how to generate a 3d mesh around a wind turbine blade?

can anybody tell me how to do that in Ansys Meshing or ICEM?

federvo.mala · March 27, 2012, 09:27

hey there, we talked once about this some months ago I remember.

making a first volume mesh on icem for a wind turbine is not that hard. but you need to go through tutorials first such as the pdf for icem 11.

you basically need to create a volume aroud the blade, create surfaces, body, make sure is 'water-tight' and then compute volume mesh.

Then of course to create a good quality one, there will have to be practice and patience.

March 26, 2012, 17:04	3d mesh around a wind turbine blade	#1
James Hetfield Member Join Date: Oct 2011 Location: OH, USA Posts: 77 Rep Power: 14	Ive seen many posts here about this issue but nobody has explained step by step how to generate a 3d mesh around a wind turbine blade? can anybody tell me how to do that in Ansys Meshing or ICEM?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Virtual Blade Model (VBM) for wind turbine.	teymourj	FLUENT	27	July 4, 2018 07:03
FSI - Wind Turbine	AUN	CFX	13	August 29, 2012 16:44
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
Help ( rotor blade design in wind turbine)	shan	FLUENT	3	June 3, 2009 03:57
how to obtain mesh file of cooled turbine blade	rajesh kumar gupta	FLUENT	0	October 18, 2007 04:18

March 27, 2012, 09:27		#2
federvo.mala Member Join Date: Sep 2011 Location: United Kigdom Posts: 51 Rep Power: 15	hey there, we talked once about this some months ago I remember. making a first volume mesh on icem for a wind turbine is not that hard. but you need to go through tutorials first such as the pdf for icem 11. you basically need to create a volume aroud the blade, create surfaces, body, make sure is 'water-tight' and then compute volume mesh. Then of course to create a good quality one, there will have to be practice and patience.