CFD Online Logo CFD Online URL
Home > Forums > Software User Forums > Autodesk Simulation CFD

cfDesign wind tunnel

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Search this Thread Display Modes
Old   September 18, 2006, 09:58
Default cfDesign wind tunnel
Posts: n/a
Can i know how to make a wind tunnel test using cfDesign? i have already make a car model using solid edge, a in-depth guide is preferable since i have almost none CFD knowledge, thanks in advance.
  Reply With Quote

Old   September 19, 2006, 08:37
Default Re: cfDesign wind tunnel
Hareesh K T
Posts: n/a
Kit, First you need a fluid mesh, for which you may substrat the existing car volume from wind tunnel volume and then mesh it. provide finer mesh near to the car boundary surface. with a Y+ value preferably <5. Boundary conditions: known mass flow rate at inlet; pressure boundary condition (ambient)at outlet. hope this is enough for you to start with.
  Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
flow in cyclic wind tunnel yogesh@cfd Main CFD Forum 0 November 8, 2010 05:28
how to consider perforated wind tunnel wall in CFD simulation littlelz CFX 4 June 11, 2009 06:51
cfDesign wind tunnel kit Phoenics 0 September 18, 2006 09:55
Virtual Wind Tunnel in FLUENT ND FLUENT 0 April 7, 2006 08:43
Wind Tunnel Website now online Mike Worthey Main CFD Forum 0 June 6, 2000 03:27

All times are GMT -4. The time now is 06:50.