|June 20, 2014, 06:53||
beyond physics results
Join Date: May 2012
Posts: 147Rep Power: 6
I am trying to simulate some elbows. R134a saturated, 250kPa at inlet, 7.9kg/s at outlet. 10in die inlet, 6" dia outlet. Mesh with autocorrect, pretty fine.
What I get is 70 000m/s at subsonic flow, pressures of -420MPa at compressible flow, and the gas turns to liquid and back. 5 or 20 iteration, no difference. So, what did I do wrong?
|Thread||Thread Starter||Forum||Replies||Last Post|
|lid driven cavity varying results||yasmil||OpenFOAM Running, Solving & CFD||2||October 6, 2016 21:42|
|CFD results not close to experimental results||cider||STAR-CCM+||0||July 8, 2013 07:53|
|OpenFOAM - Validation of Results||Ahmed||OpenFOAM Running, Solving & CFD||9||June 22, 2011 18:59|
|Different Results from Fluent 5.5 and Fluent 6.0||Rajeev Kumar Singh||FLUENT||6||December 19, 2010 12:33|
|Velocity spots in openFoam results||Valle||OpenFOAM Running, Solving & CFD||4||August 19, 2009 05:53|