|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I am doing mixed flow pump analyses with cfdesign v7 and v9. In the volume where I defined as rotating region I couldn't see any defects. Pathlines are always following the blades smoothly. Only feedback that I can obtain from the software is the torque of the rotating region. How can I benefit from other features? How can I use the outputs of a analysis in re-designing or in design of a new impeller? Thank you for your attention.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Vacuum pump simulation | Alasdair | Main CFD Forum | 3 | March 3, 2011 01:00 |