temperature contour
Hi
I want to see temperature contours in a SI Engine. I calculated it from CA 360 to CA 869. and it contains combustion. when I want to see contours, I use impress cuts and I load the calculation in 860 CA. I expect to see only cylinder that piston is near bottom dead center, but I see piston is at top dead center and inlet valve is open(exactly like 360 CA condition)! what is the reason that I confront this problem? thanks... |
Hi...
In property window you can select every step that you want. |
All times are GMT -4. The time now is 09:23. |