|
[Sponsors] |
December 22, 2013, 02:10 |
temperature contour
|
#1 |
Member
shahrbanoo
Join Date: Mar 2013
Posts: 63
Rep Power: 13 |
Hi
I want to see temperature contours in a SI Engine. I calculated it from CA 360 to CA 869. and it contains combustion. when I want to see contours, I use impress cuts and I load the calculation in 860 CA. I expect to see only cylinder that piston is near bottom dead center, but I see piston is at top dead center and inlet valve is open(exactly like 360 CA condition)! what is the reason that I confront this problem? thanks... Last edited by shahrbanoo; December 22, 2013 at 03:31. |
|
December 24, 2013, 06:10 |
|
#2 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Hi...
In property window you can select every step that you want. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plot pressure distribution on a section of 3d blade | Dr.been | FLUENT | 2 | July 22, 2016 05:03 |
"Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 10:08 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
problem in pressure gradient plot | kmgraju | CFX | 1 | March 10, 2013 16:52 |
Pressure BC for combustion chamber | Giuki | FLUENT | 1 | July 19, 2011 11:35 |