Connecting 3 separated meshes

amin_u50 · April 28, 2014, 00:13

Hi every body. I separately generate 3 volume meshes which encompass cylinder, pre-combustion chamber and cylinder's bowl. I want to connect these meshes in a certain location. I was wondering whether it is possible to connect these meshes or not by means of AVL FIRE? I appreciate it

Best regards
Amin Yousefi

cfdvenkatesh · May 16, 2014, 13:16

I couldn't understand your question completely. You could try FAME Assembly to connect Moving meshes or static and moving meshes.

amin_u50 · July 1, 2014, 04:57

Hi dear

Do you know how Fame Engine Assembly work? I have 2 static mesh ( Bowl+Prechamber) and one moving mesh (Cylinder). Can I define a specific point to joint Cylinder and Bowl or not?

Best Regards
Amin_u50

cfdvenkatesh · July 9, 2015, 10:03

I need some pictures to understand your problem. Please send me private message or e-mail, so we could discuss.

April 28, 2014, 00:13	Connecting 3 separated meshes	#1
amin_u50 Senior Member amin u3fi Join Date: Feb 2013 Posts: 137 Rep Power: 13	Hi every body. I separately generate 3 volume meshes which encompass cylinder, pre-combustion chamber and cylinder's bowl. I want to connect these meshes in a certain location. I was wondering whether it is possible to connect these meshes or not by means of AVL FIRE? I appreciate it Best regards Amin Yousefi

May 16, 2014, 13:16		#2
cfdvenkatesh New Member Venkatesh V Join Date: Sep 2009 Posts: 24 Rep Power: 16	I couldn't understand your question completely. You could try FAME Assembly to connect Moving meshes or static and moving meshes. amin_u50 likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Read parallel meshes	dl6tud	OpenFOAM Programming & Development	2	March 7, 2014 03:45
Hex and Tet meshes - simplefoam comparison	danvica	OpenFOAM Running, Solving & CFD	10	January 4, 2013 01:18
Getting prism to inflate into mixed tet-hex meshes	Joe	CFX	16	October 10, 2011 07:06
Connecting copies of meshes to a single mesh	Louis Le Grange	OpenFOAM	2	November 14, 2009 08:01
Large 3D tetrahedral meshes	Aldo Bonfiglioli	Main CFD Forum	4	August 27, 1999 03:33

July 1, 2014, 04:57		#3
amin_u50 Senior Member amin u3fi Join Date: Feb 2013 Posts: 137 Rep Power: 13	Hi dear Do you know how Fame Engine Assembly work? I have 2 static mesh ( Bowl+Prechamber) and one moving mesh (Cylinder). Can I define a specific point to joint Cylinder and Bowl or not? Best Regards Amin_u50

July 9, 2015, 10:03		#4
cfdvenkatesh New Member Venkatesh V Join Date: Sep 2009 Posts: 24 Rep Power: 16	I need some pictures to understand your problem. Please send me private message or e-mail, so we could discuss.